Results tagged “current regulation” from The GPSy EV Project

Well, my favorite discrete component of the week has to be the lowly LM317 voltage/current regulator. As one of my previous posts showed, I'm using it to current regulate some high power LEDs and I also use it as a voltage regulator.

Here's the quick and easy way to wire up an LM317 as a voltage regulator:

where the values of R2 and R1 are calculated as follows to give Vout:

R2 is usually set to 240 ohms and you can ignore Iadj to a point. Rearranging the equation gives you:

So if you want a 5 volt output, then R2 = 720 ohm (and R1 = 240 ohm). The TO-220 form factor of the LM317 that I'm using can provide up to 1.5 amps of output current and can be paralleled if I need more.

Late update: or you can just use an online calculator: http://www.jlab.org/~hansknec/index.html

DealExtreme is one of my favorite online stores. It's a distributor of inexpensive electronic gadgets based in China. I'm always finding something new there. The latest treasure is this little-but-very-bright bare LED:

DealExtreme lists it as a 10 watt LED (SKU 5876). Unbelievably it's just under $12 with shipping included!

Looking at the die shows that it is 9 discrete high-powered white LEDs in a single package. DealExtreme is bad about specs, but the comments in the DX forum seem to suggest that 700 mA at 12 volts is a reasonable spec for this LED. This would yield 8.4 watts.

(I'm wondering though if it isn't 3 x 350 mA @ 3.5 serial LEDs in a 3 parallel strings, which would be 1050 mA @ 10.5 volts. But for now, I'll run it at 700 mA).

DealExtreme lists it as 500-600 lumens @ 6500K color temperature.

As with most LEDs, you need a good current regulated driver circuit since you can't just run these things off a resistor. I decided that the easiest and simplest driver would be one based off the amazingly versatile LM317 chip.

As before, these sites have good javascript based circuit diagrams for calculating LED driver circuitry:

• http://diyaudioprojects.com/Technical/Voltage-Regulator
• http://www.reuk.co.uk/LM317-Current-Calculator.htm

Plugging my values (700 mA) into them yielded the need for a 1.8 ohm resistor with my LM317. Here's the schematic that I designed around those figures (courtesy of ExpressPCH):

Bodged together and plugged into a li-ion pack from my model helicopter and voila, an amazing amount of light. I'm thinking of using it on the headlight of my Piaggio (which currently uses a 3-watt LED) or to replace the bulb on my old 15-watt Niterider headlight, which has seen happier days.

(More photos and photometric testing after the jump)